McHale Fusion 3 - Page 50

McHale Fusion 3 Baler & Wrapper
50
4. Open the refill
5. Screw the cartridge holder onto the
pump, but do not tighten. Only screw
the cartridge by one turn when you
feel the first thread.
6. Rock the cartridge holder from side to
side to ensure it does not fall off
7. Release the plunger and push the
plunger rod all the way into the
cartridge holder
8. Slowly and gently, rock the cartridge
holder from side to side. Air between
the grease pump and the cartridge
will escape. When a bead of grease
starts to leak out, the cartridge can be
tightened fully.
9. Clean off this bead of grease so dust
and debris does not stick to it. This
dirty grease could get into the grease
pump at the next cartridge change,
causing a blockage of the grease
system.
10. Drop the plunger lock and top up the
chain oil. Then reset the lube count
on the Expert Plus Control Box.