GASOLINE ENGINES BRAVO MODELS
Page 50 of 116
4. Install both rear engine mounting bolts and hardware as shown. Torque to 38 lb-ft
(51 Nm). Do not relieve hoist tension.
5. Align engine as follows:
a. Fold perforated area in bell housing dust cover.
22027
a
a-Dust Cover
CAUTION
DO NOT use an alignment tool from another manufacturer. Alignment tools other
than Quicksilver Alignment Tool may cause improper alignment and damage to
gimbal bearing and/or engine coupler.
CAUTION
To avoid damage to gimbal bearing, engine coupler,or alignment tool:
• DO NOT attempt to force alignment tool!
• DO NOT raise or lower engine with alignment tool inserted (or partially inserted) in gim-
bal bearing or engine coupler.
b. Attempt to insert the solid end of the alignment tool through the gimbal bearing and
into the engine coupler splines.
CAUTION
Avoid damage to exhaust system. On V6 Models with one-piece exhaust manifolds,
stress can be placed on the lower exhaust pipe if front of engine is raised too high
while performing engine alignment. Ensure that engine is not raised higher than the
top of engine mount adjusting stud.
75129
a
a-Do Not Raise Above Top Of Stud
To Next Page
Loading...
