Mercusys AC12G - Ipv6

44
Chapter 4
4.8 IPv6
This function allows you to enable IPv6 function and set up the parameters of the
router’s Wide Area Network (WAN) and Local Area Network (LAN).
1. Visit http://mwlogin.net, and log in with the password you set for the router.
2. Go to Advanced > IPv6, and you can view the current IPv6 status information of
the router.
3. Enable IPv6 and select the mode: Router or Pass-Through (Bridge).
• If you select Router:
Fill in WAN and LAN information as required by dierent connection types.
• Normal: The default connection type.
1 ) Congure the WAN settings.
2 ) Congure the LAN settings. Fill in Address Prex provided by your ISP.