Wire le ss Setting , you can configure the basic settings for the wireless network
on this page.
SSID - Wireless Network Name. The default SSID is set to be MERCUSYS_ XXXX (XXXX
indicates the last unique four numbers of each router’s MAC address). This value is
case-sensitive.
Channel - This field determines which operating frequency will be used. The default channel
is set to Au t o, so the AP will choose the best channel automatically. It is not necessary to
change the wireless channel unless you notice interference problems with another nearby
access point.
Mode - Select the desired mode. The default setting is 11bgn mixed.
11b only - Select if you are using 802.11b wireless clients only.
11g only - Select if you are using 802.11g wireless clients only.
11n only - Select if you are using 802.11n wireless clients only.
11bg mixed - Select if you are using both 802.11b and 802.11g wireless clients.
11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
Select the desired wireless mode. It is strongly recommended that you set the mode to
802.11bgn mixe d, and all of 802.11b, 802.11g, and 802.11n wireless stations can connect
to the router.
Channel width - Select any channel width from the drop-down list. The default setting is
Auto, which can adjust the channel width for your clients automatically.
To Next Page
Loading...
Need help?
General
