Merging Anubis - DRIVERS INSTALLATION PROCEDURE; Windows PC - RAVENNA ASIO Driver

23
DRIVERS INSTALLATION PROCEDURE
We recommend that you first read how to POWER Up your MERGING+ANUBIS and only then
proceed with the information below.
Important. Make sure your Anubis has the most recent firmware installed. Verify the Firmware
version by going to the Settings>Info Page.
Downloads and Procedures: https://www.merging.com/anubis/download
Windows PC - RAVENNA ASIO Driver
Prerequisites:
• Gigabit Ethernet network
(A Gigabit Ethernet adapter is required in order to connect to a USB A, B or C or Thunderbolt
port).
• Windows 7 SP1 Pro - 64 bit or Windows 10 Pro - 64 bit
• DAW ASIO compatible
Installation:
1. Connect the Ethernet cable from the Anubis RJ-45 RAVENNA/AES67 port to the Ethernet
network port (1Gb) of your computer.
2. Download and install the Merging RAVENNA ASIO Driver v12 beta2 (or above) and
ANEMAN v1.1.7 beta2 (or above) from https://www.merging.com/anubis/download
Pyramix MassCore users should only install ANEMAN.
3. After the computer reboot at the end of the installation, open the Merging RAVENNA ASIO
Panel and make sure that under "Local Adapter" the Ethernet Interface to which the
Anubis is connected to is selected.