44
PRESETS Settings
Full configuration save and recall for instant switching between various projects or
configurations. Anubis ex-factory comes empty of presets, gray folders.
Load: 5 presets banks of different Anubis configurations can be loaded (one at a time)
Save: 5 presets banks are available to store different Anubis configurations
A prompt message box will ask you to confirm the save or load of a preset.
Note: During the Preset loading the Anubis Mute button will blink muting all monitors for a short period of time.
Warning: A Reboot to Factory will reboot the Anubis to the default factory settings, the current
configuration will be lost, but all the saved Presets will be kept and can be reloaded.
MONITORING Settings
The Monitoring settings are the central part of the Monitoring Mission, this is where you can
configure the incoming Sources and outgoing Monitor sets and configure their routing.
SOURCES
The first step is to configure your Sources (e.g. DAW or External RAVENNA Device) prior to
deciding how you will monitor those. By default, Anubis comes with pre-created sources that
consist of the current Anubis physical inputs: Mic/Line (Back Panel Inputs 1-2) and INST/LINE
(Front Panel inputs 3-4), with an additional DAW Source ready to listen to your DAW Playout,
upon a first connection within ANEMAN. The internal Sources are already patched to the Anubis
mix engine, so that you can immediately use them for monitoring purpose. You are free to
remove any of those pre-configured and/or to create your own additional Sources at any time.
Anubis ex-factory comes with some pre-configured Sources (such as DAW 1-2). Users are free
add and create their own sources or edit the present ones. 128 channels @ 1FS (44.1/48kHz) are
available to connect those Sources.
To Next Page
Loading...
