38
SPLIT CHANNEL
As seen on the right side of the above block diagram, the Anubis AD front-end topology gives also
additional flexibility by offering a split channel functionality, where every input channel has a
separate split gain control for sending them to different paths.
Use Case examples:
▪ Typically, an AD could be used for the recording device and have its split channel used for
the FOH.
▪ Independently control the FOH & Monitoring Microphone Gains without any conflict
▪ The Split channel gives the operator the possibility to cut an input signal to the FOH while
monitoring the same channel split that would be routed to another Monitoring set (e.g.
Headphones). For signal check, changing a defective cable or searching for a proper
sound or instrument FX, all this while muting the FOH feed.
To Next Page
Loading...
