Merging Anubis - SURROUND MONITORING CONTROL SETUP

79
SURROUND MONITORING CONTROL SETUP
SetUp:
Using Anubis monitoring controls with a RAVENNA/AES67 device such as Horus or Hapi
integrated in a network Studio setup and used for their multichannel capabilities. In the setup
here Anubis will be the Monitoring Controller for a 5.1 surround monitor set, played out from a
DAW multichannel bus through the Horus DA8.
Prerequisites:
At least two RAVENNA/AES67 compliant devices, such as Anubis & Horus or Anubis & Hapi,
along with a RAVENNA/AES67 recommended network switch. Make sure you have followed the
User Manual section on the Drivers Installation procedure.
Note: Horus and Hapi devices have to be on Firmware 3.9.4 and higher