43
Date
Set the date by tapping each field (Day: Month: Year) one by one and using the Anubis Rotary
Knob to adjust it.
Time
Set the date 24-Hours format by tapping each field (Hours: Minutes: Seconds) one by one and
using the Anubis Rotary Knob to adjust.
Note: The Date and Time changes will be saved once you exit the Anubis Settings or if you Save the
current configuration from Settings>Exit>Save
METERS Settings
Hot (near clipping)
Sets the metering level Hot range (white). If set to 0dB this will mean clipping.
Range -2dBFS to 0dBFS
Default: -0.2dBFS
Note: When reaching a level of 0dBFS (digital clipping) the meter top led will display a Red peak.
Alignment (reference level)
Sets the metering level Alignment range (light-gray).
Range -24dBFS to 0dBFS
Default: -18dBFS
Decay Integration Time
Sets the rate at which the level meter display decays after the level falls below the most recent
Peak.
Choices: OFF - 25 ms/dB - 50 ms/dB - 75 ms/dB - 100 ms/dB
Default: 25ms/dB
Peak Hold
Enabling Peak Hold allows the meter to continue displaying the highest signal level permanently,
until it is exceeded by an even higher peak. This is very useful, as it gives clear indications of
where and how hot peaks are, but still allows monitoring of the current signal level.
To Next Page
Loading...
