Metrohm 780 - Menu Structures; Instrument Configuration

9.3 Menu structures
144
780/781 pH/Ion Meter, Manual
9.3 Menu structures
The menu structures of the instrument configuration and the method
parameters of all operating modes are shown on the following pages.
This so-called instrument tree can also be used to control the pH/Ion
Meter via the serial interface. It is described in a separate document to-
gether with the exact syntax used (780/781 pH/Ion Meter Operation via
RS232, No. 8.781.1113). The document is available from your local
Metrohm agency.
9.3.1 Instrument configuration
CONFIG
├ report
│ ├ id1
│ ├ id2
│ ├ report id
│ ├ instrument id
│ ├ date & time
│ ├ method
│ ├ electrode id
│ ├ signature
│ └ line feed
│
├ print meas.value
│ └ print crit ────┬ immediate ┬ date & time
│ │ ├ report header
│ │ └ calibration report
│ ├ time ┬ date & time
│ │ ├ report header
│ │ ├ calibration report
│ │ ├ time interval
│ │ └ stop time
│ ├ drift ┬ date & time
│ │ ├ report header
│ │ └ calibration report
│ ├ plot ┬ time interval
│ │ ├ time scale
│ │ ├ time scale label
│ │ └ stop time
│ └ OFF
├ store meas.value
│ └ store crit ────┬ immediate, drift, OFF
│ └ time ┬ time interval
│ └ stop time
: