5.4 Auxiliaries
48
780/781 pH/Ion Meter, Manual
5.4 Auxiliaries
CONFIG
:
├ auxiliaries
: ├ run number
├ last digit
├ dialog
├ display
├ LCD off after
├ date
├ time
├ time zone
├ temp.sensor
├ temp.unit
├ device label
├ beep
Various basic settings for the configuration of the pH/Ion Meter are
made in this submenu.
run number 0,1,2,3...999, OFF
The run number is included in the report. It is increased by one after
each measuring process. This applies to both the storage of measured
values and to the calibration or pH electrode test and makes the later
chronological assignment of such different measuring processes easi-
er.
When the instrument is switched on the run number is automatically set
to '0'. The first measuring process begins with '1'.
last digit: ON, OFF
This setting can be used to conceal the last decimal place of the meas-
ured value display. The displayed value is rounded off accordingly. This
can be useful in improving the readability of a rapidly changing meas-
ured value. Please note that this setting does not influence the drift con-
trol of a measurement.
dialog: english, deutsch, français, español
The dialog language covers both the language shown on the display
and that used in the report. Switch the instrument off and on if this set-
ting has been changed.
display: positiv, negativ
You can choose whether you want to have a positive or negative dis-
play presentation, e.g. in order to adapt it to the local lighting condi-
tions.
To Next Page
Loading...
