Metrohm 780 - Arrangement of a Report

7.2 Reports
98
780/781 pH/Ion Meter, Manual
7.2.1 Arrangement of a report
The first lines of a report provide a general description. This report
header is configured under
CONFIG/Report (see Section 5.1):
Report Id:
'mp
Instrument Id:
781 pH/Ion Meter 01104 5.781.0020
Date, Time:
date 2004-05-28 17:00:56
...
For the output of data as measuring points, results, calibration or elec-
trode test reports further information about the mode, method, sample
number and electrode Id is included:
Report Id:
'mp
Instrument Id:
781 pH/Ion Meter 01104 5.781.0020
Date / Time:
date 2004-05-28 17:00:56
User:
user C. Weber
Mode / Method / Run number:
pH pH-1 run number 9
Electrode Id:
electr.id pH electr.1
...
Signature:
Visum _______________________________
Depending on the configuration, in such measuring data reports a sig-
nature line can be added to the data.
The line 'user' appears, if a user is defined by
<USER>
.
If you have entered an instrument name under CONFIG/auxiliaries/
device label
then this will appear in the report header as an addi-
tional line between the Instrument Id and the Date/Time line.
In measuring point and result reports the report header contains addi-
tional information about the measured sample as
Id 1 and Id 2, if
these have been defined under
CONFIG/report or are requested be-
fore the measurement as a preselection (see
PARAMETER/pre-
selections
).
Each report is concluded with a finishing line. For an
automatically
trig-
gered
original report
(measuring points, results, calibration or electrode
test reports) this is in the form of a
double line
:
==============
Each report to be triggered
manually
with
<REPORT>
is concluded
with a
single line
:
--------------