Micros Systems Workstation 4 - Starting the Workstation for the First Time; Using SUSPEND

3-12 Workstation 4 Setup Guide
Installing and Operating the Workstation 4
Operation
Starting the Workstation for the First Time
When a new workstation is powered up for the first time, through a register
setting, the CAL starts and determines (by checking other registry settings) that
a POS application is not installed. CAL presents User Interface (UI) and
proceeds to search the network for a server running the CAL service. When
contact is established, a list of computers running CAL server are displayed.
1. Double click the server entry. This will connect you to the device database
and display a list of pre-programmed Workstation 4s. See your application
programming documentation.
2. Select your Workstation 4 from the list. Double-click the entry.
• Each workstation is pre-programmed with a workstation name, IP
address, and other application related settings. This information is
downloaded to the workstation and placed in the registry.
• If the version of the CAL on your workstation is older than the version
of CAL on the server, CAL will update itself before proceeding to
download the application.
• The Workstation proceeds to download the application ‘package’ and
automatically reboots when complete. When the reboot is complete the
CAL automatically starts the application.
Using SUSPEND
The Workstation 4 can be placed in SUSPEND by the operator when it will not
be used for a period of time. SUSPEND differs from the NOPOWER state in
that memory contents are preserved. Restoring the unit from the SUSPEND
state to ON takes less time than the NOPOWER to ON sequence described
above.
Entering SUSPEND
1. When the WS4 is ON, press and the power button for less than two
seconds, then release it.
• The Operator LED indicator changes from solid Green to solid Amber.
• The Operator LCD is blank. If a customer display is attached, it will be
blank as well.
• When in the SUSPEND mode, the WS4 will not respond to
touchscreen, swiping a magnetic card, or using any peripheral device.
The power button must be used to return the unit to the ON state, as
described below.
Turning the WS4 from SUSPEND to ON
1. When the WS4 is in SUSPEND, press and release the power button for one
second.