Miller Continuum User Manual

OM-266409 Page 50
”V” GROOVE FOR HARD WIRE
”U” GROOVE FOR SOFT
*
SHELLED
CORED WIRES
”V” KNURLED FOR HARD
*
SHELLED
CORED WIRES
”U” COGGED FOR EXTREMELY SOFT WIRE OR SOFT* SHELLED CORED WIRES
”U” GROOVE FOR ALUMINUM WIRES CONTAINS NYLON WIRE GUIDES
WIRE SIZE .023/.025 in. (0.6 mm) 151024 .030 in. (0.8 mm) 151025 .035 in. (0.9 mm) 151026 151052 243233 .040 in. (1.0 mm) 161190 .045 in. (1.1/1.2 mm) 151027 151037* 151053 151070 243234* .052 in. (1.3/1.4 mm) 151028 151038 151054 151071 1/16 in. (1.6 mm) 151029 151039 151055 151072 243235 .068/.072 in. (1.8 mm) 151056 5/64 in. (2.0 mm) 151040 151057 151073 3/32 in. (2.4 mm) 151041 151058 151074 7/64 in. (2.8 mm) 151042 151059 151075 1/8 in. (3.2 mm) 151043** 151060** 151076** *Accommodates .045 and .047 (3/64 in) wire **Requires a low
*speed wire feeder
Wire Guides Nylon Wire Guides for Feeding Aluminum Wire Wire Sizes Inlet Guide Intermediate Guide Wire Size Inlet Guide Intermediate Guide .023 to .040 in. (0.6 to 1.0mm) 221030 149518 .035 in. (0.9mm) 221912 242417 .045 to .052 in. (1.1 to 1.4mm) 221030 149519 .047 in. (1.2mm) 221912 205936 1/16 to 5/64 in. (1.6 to 2mm) 221030 149520 1/16 in. (1.6mm) 221912 205937 3/32 to 7/64 in. (2.4 to 2.8mm) 229919 149521 1/8 in. (3.2mm) 229919 149522
Table 10-1. Drive Roll And Wire Guide Kits

Miller Continuum Specifications

General

Brand	Miller
Model	Continuum
Category	Welding System
Language	English