Introduction Replacement Parts
7 - 2 046-001141-00 A5/A3™ Service Manual
7.1 Introduction
The A5/A3 anesthesia system can be broken down into 18 big parts based on its structure and
function. Each big part includes several replaceable parts. Tables 8-1 through 8-18 list the information
about each replaceable part and Figures 8-1 through 8-14 indicate the position of each replaceable
part on the A5/A3. The selection of replaceable parts gives consideration to the characteristics of the
parts, cost of replacement, and maintenance efficiency. When the parts whose sub components are
not convenient to replace (such as the electronic component on the board) are faulty, replacing the
board can improve the maintenance efficiency. For example, if a pressure gauge on the instrument
panel is faulty, replacing the pressure gauge can reduce the cost.
7.1.1 Ordering Replaceable Parts
NOTE: The primary differences between New A5 and Original A5 are as
follows:
1.Silkscreen difference(changed from 10C to 8C). There is little
difference for most of the materials.
2. Color difference of the base, caster and display front housing: blue
for Original A5 and dark blue for New A5.
3. Meter panel difference: New A5 has borders while Original A5 does
not have.
4. O2 concentration monitoring difference: New A5 has module rack
and its uses AG module with O2 for O2 con
Provide the following information to order replaceable parts:
FRU code of the parts;
Number of the parts in the document table;
Description of the feature of the parts.
For example: P/N: 115-018165-00 .............................................................................................. Auxiliary gas supply, NO.1
To Next Page
Loading...
Need help?
General
