Mindray A8 - Alarm Reset; Alarms; Audio Pause; Cardiac Bypass Mode

Operator’s Manual of Anesthesia System 4 - 27
System Interface Setup Menu
• The fresh gas flow resumes at the settings from before entering the [Flow Pause] state.
• Ventilation resumes in the same ventilation mode and with the same parameter settings as before entering
the [Flow Pause] state.
• Physiological alarms related to ventilation and gas are enabled.
4.6.4 Cardiac Bypass Mode
See (Pages 6-19) 6.7.3 "Cardiac Bypass Mode".
4.6.5 Screens
Select the [Capture Event/Screen] soft key, and the system will save the current screen as an image
in the [png] format and log the current monitoring and event to the Event Log (See Pages 4-25
"Event Log" ). The anesthesia system can store up to 50 images.
4.6.6 Alarms
Select the [Alarms] soft key on the Main Screen to open the [Alarms] menu where you can set the
alarm limits and view active alarms (See (Pages 8-1) 8.0 "Alarms and Messages").
4.6.7 Alarm Reset
See (Pages 8-8) 8.6 "Setting Alarm Limits".
4.6.8 Audio Pause
See (Pages 8-7) 8.4 "Pause Alarm Audio".
4.7 Setup Menu
Select the icon to open the [Setup] menu (Figure 4-34).
NOTE: The [System] soft key is only available in the standby mode.
NOTE: The [Service] tab is for use only by Mindray Technical Service. Please
contact Mindray Technical Support for details.