Operating Your Analyzer
6-16
z When the PLT value is less than 100 × 10
9
/ L, a manual count by the
microscope is recommended.
Adjusting histograms manually
If you are not satisfied with the obtained histograms, you can adjust them manually, provided
you have the administrator password. See Chapter 7 Reviewing Sample Results for
details.
Screen saver
This analyzer will enter the screen saver if it has been idle at the “Count” screen for 10
minutes. When it happens, the sample probe will retract into the analyzer, the LCD will turn
dark and the power indicator will be flickering. You can press any key to resume the display
and replace the sample probe.
To Next Page
Loading...
