Customizing the Analyzer Software
5-26
5.8 Auto Clean Time
The “Auto Clean Time” screen is where you set the interval for auto cleaning of the fluidic
lines. The valid interval is 2 - 24 hours and the default interval is 4 hours. To set the interval,
Press [MENU] to enter the system menu.
Figure 5-35 System menu
SELECT “Setup→Auto Clean Time” (Figure 5-35) to enter the “Auto Clean Time” screen
(Figure 5-36).
Figure 5-36 “Auto Clean Time” screen
ENTER the desired interval. Press [MENU] to exit to the system menu or [MAIN] to exit to the
“Count” screen, and the changes will be saved automatically.
To Next Page
Loading...
