Installing Your Analyzer
4-4
4.3 Unpacking
4.3.1 Unpacking and Inspecting the Analyzer
Your analyzer is tested before it is shipped from the factory. International symbols and special
handling instructions tell the carrier how to treat this electronic instrument. When you receive
your analyzer, carefully inspect the carton. If you see any signs of mishandling or damage,
contact Mindray customer service department or your local distributor immediately. When you
are sure the carton is fine, follow the steps below to unpack the analyzer:
1. Place the carton on the floor upright with the arrows on the side upwards;
2. Remove the tape and take out the accessory box. Check the accessories against the
packing list. Notify the Mindray customer service department or your local distributor
immediately if you find anything missing;
3. Open the main box and check the items inside against the packing list. Notify the Mindray
customer service department or your local distributor immediately if you find anything
missing;
4. Remove the top protective foam. Firmly grip the two cardboard handles and lift the
analyzer out of the box and place it on the floor. Carry the analyzer away from the foam
and set it on the countertop.
z Be sure to retain the shipping carton and all the packing materials, as they
can be used for packaging if analyzer must be reshipped.
4.3.2 How to move the analyzer
If the carton is intact, you may use a plate and fork-lifter to move the analyzer for a short
distance;
If your analyzer has been used for a while, do the”Empty Tubing” procedure and shut it
down before moving it;
To Next Page
Loading...
