Mindray BC-3000 Plus - 7.2 Browsing All Sample Results

Reviewing Sample Results
7-2
7.2 Browsing All Sample Results
To browse all the saved sample results, you can choose either of the following modes:
 The “Sample Table Review” mode. In this mode, the sample results are presented in a
columnar fashion without histograms (namely you can only see the parameter values). One
screen displays maximum 6 sample results.
 The “Sample Histogram Review” mode. In this mode, you can review both parameter
values and histograms of the saved sample results. One screen displays one sample result.
7.2.1 Browsing in the “Sample Table Review” mode
Entering the “Sample Table Review” screen
Press [MENU] to enter the system menu. SELECT “Review→ Sample Review→ Sample
Table Review” (Figure7-1 ), to enter the “Sample Table Review” screen (Figure7-2).
Figure7-1 System menu
The sample results are sequentially displayed on the screen, the earliest on the utmost left.
The “Location/Total” displayed in the lower right corner of the screen indicates the location
of the current sample result (the one whose “ID” is backlit) and the total number of the saved
sample results.