Installing Your Analyzer
4-16
4.5 Starting the Analyzer
Take out the power cord from the accessory box. Plug the non-pronged end into the AC input
at the back of the analyzer and the pronged end into an electrical outlet. Place the power
switch at the back of the analyzer in the ON position (1) to turn on the analyzer. The power
indicator light will be illuminated and the screen will display “Initializing…“. The analyzer will
sequentially initialize the file, hardware and fluidic systems and the whole initializing process
lasts about 3 - 4 minutes. When the initialization is finished, the analyzer will automatically
enter the “Count” screen.
To Next Page
Loading...
