C-1
C Precautions, Limitations and Hazards
C.1 Introduction
You will find the following symbols in this manual.
When you see… Then…
read the statement below the symbol. The statement is
alerting you to an operating hazard that can cause
personnel injury.
read the statement below the symbol. The statement is
alerting you to a possibility of analyzer damage or unreliable
analysis results.
read the statement below the symbol. The statement is
alerting you to information that requires your attention.
read the statement below the symbol . The statement is
alerting you to a potentially biohazardous condition.
C.1.1 Installation Requirements
All the space, power and environmental requirements listed in Chapter 4 and Appendix B
must be met. Establishing and maintaining prope grounding cannot be overemphasized.
C.1.2 Limitations
Whenever the results are outside the normal limits, it is recommended that the laboratory
following whatever written protocol is in place for validating results.
If an error occurs, the analyzer displays the corresponding error message In case of errors
related to the fluidic system (such as clogging or bubbles), it is recommnended that you
re-run the sample after removing the error.
If the PLT value is less than 100 × 10
9
/ L, it is recommended the result be verified by a
microscope.
C.1.3 Maintenance
The maintenance instructions in Chapter 10 decribe corrective and preventive procedures
that must be followed to ensure proper operation and performance of your analyzer.
To Next Page
Loading...
