Using the QC Programs
8-5
Figure8-5 An“Invalid date”message box
If all the entries are correct, a message box will pop up to remind you to save the changes, as
Figure8-6 shows. CLICK “Enter” to save the changes and exit to the system menu (or the
“Count” screen); CLICK “Cancel” to abort the changes and exit to the system menu (or
the “Count” screen).
Figure8-6 A message box to confirm the changes
8.2.2 Running the Controls
Selecting the “Whole Blood” mode
Press [MENU] and SELECT “Mode” to enter the “Sample Mode”screen. SELECT “Whole
Blood” from the “Sample Mode” pull-down list.
Entering the “L-J Count” screen
Press [MENU] to enter the system menu. SELECT “Quality Control→L-J Analysis → L-J
Count →File 1” to enter the “L-J Count”screen, as Figure 8-7 shows.
To Next Page
