Using the QC Programs
8-12
Browsing results of L-J analyses
Press [↑] or [↓] to review the preceding or following screen; press [←] or [→] to review the
preceding or following result. The parameter value of the current point (the one the cursor is
located at) is displayed below the parameter box. The location of the current point is
displayed in the “No.” field. The analysis time is displayed in the “Time” field.
Printing L-J graphs
Press [PRINT] to print out the displayed L-J graphs.
Exiting the “L-J Graph” screen
Press [MENU] to exit to the system menu, or press [MAIN] to exit to the “Count” screen.
“L-J Table” mode
Entering the “L-J Table”screen
Press [MENU] to enter the system menu.
Figure8-13 System menu
SELECT “Quality Control → L-J Analysis →L-J Table → File 1” (Figure8-13) to enter the
“L-J Table” screen (Figure 8-14). Every screen displays 5 results. The parameter values
fallen outside the expected range will be flagged “H” (higher than the upper limit) or “L” (lower
than the lower limit).
To Next Page
Loading...
