Mindray M9 User Manual

3-16 System Installation
2. Scan the following 1-D barcode to enable the suffix:
For scanning Barcode
For scanning RFID
Notes:
Users can customize the JADAK barcode reader based on
specific requirements or contact the Mindray service
engineers. This configuration guide is applicable for the
Ultrasound System only.
Reset the barcode reader
1. If the barcode reader is in malfunction, scan the following 1-D barcode to reset to default
settings.
2. Follow the following steps to reconfigure the barcode reader:
a) Scan the following 1-D barcode to configure the barcode reader:
b) Scan the following 1-D barcode to enable the suffix:
For scanning Barcode
For scanning RFID
c) Scan the following 1-D barcode to disable the prefix:
For scanning Barcode
For scanning RFID

Mindray M9 Specifications

General

Type	Portable Ultrasound System
Battery	Rechargeable lithium-ion battery
Battery Life	Up to 90 minutes
Display	15.6 inch high resolution LED monitor
Imaging Modes	B, M, Color, Power, PW, CW
Transducers	Linear, Convex, Phased Array
Transducer Ports	3
Probe Connectors	3
Connectivity	DICOM, USB, HDMI
Operating System	Windows-based