Mindray SV300 User Manual

13-7
SpO
2
module upgrade package (adult) 115-028396-00 /
SpO
2
module upgrade package
(pediatric)
115-028395-00 /
HEPA filter HEPA filter 045-001333-01 ZJNF
Dust filter Air intake dust filter 045-001298-01 Guozhihuifu
Gas supply hose
assembly
Gas supply hose assembly, O
2
supply,
European standard
34I-OXY-DS/NS-0.6
082-001926-00 GENTEC
Gas supply hose assembly, O
2
supply,
American standard
34U-OXY-DS/DS-0.6
082-001918-00 GENTEC
Gas valve
Gas valve, high-pressure cylinder
pressure reducer, 14Mpa
082-001927-00 GENTEC
Low pressure oxygen
connector
Connector, straight, white POM, with
O-ring, applicable to 3/16"ID hose
082-001920-00 CPC
* :
The pulse oximeter probes and probe cable extenders listed for this device have been
validated and tested for compliance with ISO 80601-2-61.
The SpO
2
sensor material that contacts patients or other staff has untaken the
bio-compatibility test and is verified to be in compliance with ISO 10993-1.
Wavelength emitted by the sensors intended for Mindray SpO
2
module: red light: 660 nm,
infrared light: 905 nm.
The maximum photic output consumption of the sensor is less than 18 mW.
The information about the wavelength range and maximum photic output consumption can
be especially useful to clinicians, for example, clinicians performing photodynamic therapy.

Mindray SV300 Specifications

General

Waveform Display	Pressure, Flow, Volume
Battery Backup	Up to 2 hours
Ventilation Modes	VCV, PCV, SIMV
Tidal Volume Range	20 to 2000 mL
FiO2	21 to 100%
Inspiratory Time	0.2-5.0 s
Monitoring Parameters	Paw, Ppeak, Pmean, Pplat, PEEP, VTI, VTE, MV, f, FiO2, I:E
Alarms	High/Low Airway Pressure, High/Low Minute Volume, High/Low Tidal Volume, High/Low Respiratory Rate, High/Low FiO2, Apnea, Power Failure
Power Supply	AC 100-240V, 50/60Hz
Peak Flow	180 L/min
Trigger Sensitivity (Flow)	0.5-10 L/min