5-7
5.14 Manage Default Settings
The ventilator provides the following types of settings:
Factory default settings, namely, values of factory preset setting items. There are two
groups of default settings, adult and pediatric, based on patient type.
Current settings. You can change the ventilator’s default settings based on the current
settings during ventilation and save the changed settings as default settings. There are
two groups of default settings, adult and pediatric.
Recent settings. In actual applications, you may change some settings, which, however,
may not be saved as current settings. The ventilator stores these settings in real time.
The stored settings are recent settings.
NOTE
Patient type, gender, height, IBW, ventilation mode, ventilation parameters, and
alarm limit settings can be saved as current settings.
5.14.1 Save and Load Current Settings
You can change the ventilator’s settings based on the actual requirement and save the
changed settings as current settings.
1. Select [Setup]→[Maintain]→[User]→enter the required password→[Default
Settings].
2. Select [Use Current Settings] to save as current settings.
When the ventilator is used on a new patient after powered on, the system loads the saved
current settings automatically.
5.14.2 Restore Factory Default Settings
You can restore factory default settings manually as required, while unit is in standby status.
1. Select [Setup]→[Maintain]→[User]→enter the required password→[Default
Settings].
2. Select [Restore Factory Defaults] to restore the defaults to factory defaults.
When the ventilator is used on a new patient after powered on, the system loads the factory
default settings automatically.
To Next Page
Loading...
Need help?
General