6-16
Paw
Flow
Time
△Papnea
Spontaneous breathing Apnea ventilation
PEEP
Apnea vent
cycle
Apnea Tinsp
Tslope
Apnea time
Time
In CPAP/PSV mode, you need to set the following basic ventilation parameters in Invasive
ventilation:
1. [O
2
%]: Oxygen concentration
2. [△Psupp]: Pressure support level (for PSV mode)
3 [PEEP]: Positive end-expiratory pressure
4. [F-Trig] or [P-Trig]: Inspiration trigger level
5. [Exp％]: Expiration trigger level
6. [Tslope]: Time of pressure rising
7. [TVapnea] or [ΔPapnea]: Tidal volume or inspiration pressure in apnea ventilation
cycle
8. [fapnea]: Frequency of apnea ventilation
9. [Apnea Tinsp]: Inspiration time of apnea ventilation
In CPAP/PSV mode, you need to set the following basic ventilation parameters in
Non-Invasive ventilation (NIV):
1. [O
2
%]: Oxygen concentration
2. [△Psupp]: Pressure support level (in PSV mode)
3 [PEEP]: Positive end-expiratory pressure
4 [Tinsp]: Inspiration time
5. [F-Trig] or [P-Trig]: Inspiration trigger level
6. [Exp％]: Expiration trigger level
To Next Page
Loading...