Mindray WATO EX-55Pro - 4.12 Alarm Tests

4-29
Figure 3 (withoutBYPASS) Figure 4 (with BYPASS)
4.12 Alarm Tests
4.12.1 Prepare for Alarm Tests
1. Connect a test lung or manual bag to the Y piece patient connection.
2. Set the Bag/vent switch to the
position.
3. Set the system switch to the
position.
4. Set the system to Standby.
5. Set the ventilator controls as follows:
 Ventilation mode: select [Vent Mode] and then [VCV].
 [TV]: 500 ml.
 [Rate]:12 BPM.
 [I:E]: 1:2.
 [Plimit]: 30 cmH
2
O.
 [PEEP]: OFF.
 [Tpause]: OFF.
6. Push the O
2
flush button to fill the bellows, which rises to the top.
7. Select single flow control mode of fresh gas in the main menu.
8. Turn the O
2
flow control to set the O
2
flow to 0.5 to 1 L/min.
9 Press the soft key and select [Ok] from the pop-up menu to exit Standby.
10. Make sure that:
 The ventilator displays the correct data.
 The bellows inflates and deflates normally during mechanical ventilation.