Mindray WATO EX-55Pro - Gas Bench; O2 Sensor

2-60
A. Manual inspiration mode B. Manual expiration mode
2.2.5.4 Gas Bench
The sample gas, collected by AG module from the patient end, reenters to the breathing circuit
through the CPC connector with self closing function, shown as the above figure.
2.2.5.5 O2 Sensor
O2 sensor, installed on the inspiration limb of the breathing circuit, monitors the O2 concentration
of the inspiration limb, shown as the above figure. If the O2 concentration of inspiration limb is
too low, an alarm will be triggered.
To AGSS
Drive gas
Gas breathed out by the
p
atient
CPC
connector
O2
sensor