Mindray WATO EX-55Pro - Page 209

7-13
 The following figure shows the ports on the Fluke VT Plus and the corresponding
settings:
(1). Power on the anesthesia machine calibration device Fluke VT Plus. The following figure
shows the ports on the Fluke VT Plus:
RS232 cable at the end of the calibration device (VT Plus)
Calibration apparatus
board. The board
requires additional
USB power supply in
addition to the
connection shown in
the figure.
RS232 connecting
cable, connecting
the calibration
device
RS232 connecting
cable, connecting the
anesthesia machine