IV
(2) Installation
Warning ● There are a lot of electrical parts installed on the P.C. board of the
instrument, so there have fears to occur electrostatics destruction.
Because of this, operator should discharge electricity from him/her by
touching to some metal sections other than the instrument before
use. Besides, take care not to touch to electrical parts when you
operate.
● When installing the
instrument, install as referring to the following
dimensions and secure the space around the instrument.
● When installing the instrument, we recommend you to prepare for
the cover considering the following items.
Besides, we prepares installation to cover for this instrument as an
option.
1
There are a lot of ICs on the P.C. board of the instrument that may
be destroyed eternally due to static electricity, so in order to
prevent the human from touching them directly.
2
The battery is installed on the P.C. board of the instrument, so in
order to prevent from shorting between the polarities of battery
carelessly.
3
There are some places that have high temperature around 50 ℃ or
more in the room temperature, so in order to prevent the operator
from touching to the areas carelessly.
● The protection tape for the battery polarities is applied on the part of
battery(front side) and battery terminal(rear side) of this instrument.
When you will use the instrument, peel them off
● The bag for packaging this instrument is made from the conductive
material, so don’t use this bag with the protection tape for each
battery polarities removed.
To Next Page
Loading...
