miniClima Schönbauer GmbH
Brunner Str. 21b, 2700 WIENER NEUSTADT, AUSTRIA, EU
Tel. | Phone: +43 2622 24964, +43 6991 24964 01, Voicemail: +43 6993 24964 01, Fax: +43 2622 24964 15, E-Mail: office@miniclima.com
www.miniclima.com, twitter.com/miniClima, www.linkedin.com/company/miniclima-schönbauer-gmbh, www.google.com/+Miniclima, www.facebook.com/miniclima
UID | VAT-ID: ATU61994435, EORI: ATEOS1000001229, DVR: 4008782
Firmenbuchnummer | Trade Register Number: 267137z (Landesgericht | Regional Court of Wiener Neustadt)
being issued during humidification.
Place the bottle next to the turquoise water level sensor(s) on the side or front of the device (if any; see
section 3.1 "Positioning the bottle" on p. 10) and secure the bottle with the hook-and-loop-fastener. Push the
transparent silicone hosepipe (which comes out on the left side of the EBC10 or -11, and on the front side of
the EBC12) through the 5mm-hole in the bottle's cover.
IMPORTANT: When securing the bottle with the hook-and-loop-fastener, ensure that the bottle touches the
water level sensor(s), otherwise the according alarm might not be issued correctly. Also mind, that the end of
the hosepipe reaches the bottom of the bottle, so that all the distillate/condensate in the bottle is available for
the humidification processes.
IMPORTANT: For units with only one or no water level sensors: Visually control the water level of the
operating device regularly (see also section 4.7 "Controlling, feeding, emptying and cleaning the bottle" on
p.37)!
4.2 Initial step 2 - mains connection
Use the delivered mains connection cable. At first plug the cable to the socket-inlet (backside) of the device.
Then plug the cable to an appropriate (see section 1.4 "Further requirements", p. 6) socket-outlet with
earthing contact. If necessary, you can use any common and approved international mains plug adapter -
still, voltage and frequency of the mains connection have to be within the above (p. 6) mentioned range, and
the connection has to be fuse protected and earthed.
NOTE: In case of a power outage (or when the mains connection has been cut in any other way), the EBC
will always return to the last mode it had been working in (Stand-by or humidity control) as soon as the
power supply becomes reestablished. Also, all settings that had been taken on the EBC will remain intact
despite of any power outage.
4.3 Stand-by mode
Once a working mains connection has been established the EBC's LED lights up green and the display
indicates the software version programmed into the EBC's processor. After some seconds the display
switches to:
Applies analogously to the individual products of series EBC10/11/12 (Rev.3). As of 24.11.2014. Subject
to modification.
miniClima - Manual_EBC10-11-12(Rev.3)_en
23 / 54
To Next Page
Loading...