miniClima Schönbauer GmbH
Brunner Str. 21b, 2700 WIENER NEUSTADT, AUSTRIA, EU
Tel. | Phone: +43 2622 24964, +43 6991 24964 01, Voicemail: +43 6993 24964 01, Fax: +43 2622 24964 15, E-Mail: office@miniclima.com
www.miniclima.com, twitter.com/miniClima, www.linkedin.com/company/miniclima-schönbauer-gmbh, www.google.com/+Miniclima, www.facebook.com/miniclima
UID | VAT-ID: ATU61994435, EORI: ATEOS1000001229, DVR: 4008782
Firmenbuchnummer | Trade Register Number: 267137z (Landesgericht | Regional Court of Wiener Neustadt)
7) Check if the fuse broken. If yes, replace it with a new one ( CAUTION: For a continued protection
against fire replace only with a fuse of the same type and rating!) and continue with step 10). If not, put
the fuse back on its holder an continue with the next step.
8) Take out the fuse of the switching power supply unit (using a small screw driver with insulation):
9) Check if this fuse is broken and snap a working fuse back in ( CAUTION: For a continued protection
against fire replace only with a fuse of the same type and rating!)
10) Put the protective cover back on its place and fix it with its screws ( IMPORTANT: Beware to not
squeeze any wire!)
11) Close the cover ( IMPORTANT: Beware to not squeeze any wire or the silicone pipe!) and fasten the
screws again. Plug the mains connection back on (both the LED and display should light up now).
7.3 Cooling air in-/outlets
Dust on the air grill(s) or air slits blocks the cooling airflow, which might in consequence overheat the device
and/or reduce its dehumidification capacity. Therefore, and depending on the condition of the surrounding air,
especially the cooling air inlet on the right side (EBC10/11/12) as well as the one on the left side (EBC12)
has to be checked/cleaned regularly: Vacuum clean the mounted grill(s) from the outside regularly. From
time to time you should take the filter(s) out for washing or for replacing it/them:
1) Turn the EBC off by pushing and holding On-Off/Reset for about a second. Slaves are switched
automatically with their master. Then, wait for the pump process to be completed (if any) and (
IMPORTANT) pull the mains plug.
2) Unscrew the respective grill, take out the dust filter, and wash or replace it with a new one.
3) Put the new or washed (and dried) filter back on its place and fix the grill on the device again.
4) Plug the mains back on and put the EBC back to work.
From time to time you should also check the cooling air outlets (top and bottom), whether or not they need
cleaning with a vacuum cleaner, too. Mind to not move the operating device, though: Turn it off (slaves are
switched via their master), let it finish with its pumping process (if it comes after having turned off), and pull
Applies analogously to the individual products of series EBC10/11/12 (Rev.3). As of 24.11.2014. Subject
to modification.
miniClima - Manual_EBC10-11-12(Rev.3)_en
50 / 54
To Next Page
Loading...