•
•
•
•
•
•
Getting started
MiR200™ User Guide, Robot interface 2.0, 11/2018 v.1.2 12
4.2.2 Powering up
Follow these steps to power up the MiR200™
Step Action
1
Grab the two rounded corners and carefully lift off
the cover.
2
Connect one of the two battery cables to the
plug on top of the battery box.
The second cable is for an extra battery if
installed.
Switch on the four relays placed in the corner by the
front laser scanner. Start with 32A main power, i.e.
from the outer frame in.
To Next Page
Loading...
