MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 1
IMPORTANT NOTICE
Notice for all ADC SeriesTelephone Entry Systems Sold in Canada
The Canadian Department of Communications label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective, operational and safety requirements. The
Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunication company. The equipment must also be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions may not prevent degradations of service in
some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the
supplier. Any repairs or alteration made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the Earth Ground connections of the power utility, telephone lines
and internal metallic water pipe system, if present, are connected together. This precaution may be particularly
important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate
electric inspection authority, or electrician, as appropriate.
NOTICE: The LOAD NUMBER (LN) assigned to each terminal device denotes the percentage of the total load
to be connected to a telephone loop which is used by the device, to prevent overloading. The
termination on a loop may consist of any combination of devices subject only to the requirement that
the sum of the load numbers of all devices does not exceed 100.
Industry Canada (formerly D.O.C.) Registration Number: 1156 6662 A
Load Number: 4.4
Notice for all ADC Series Telephone Entry Systems Sold in U.S.A.
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
WARNING : Changes or Modifications not expressly approved by MIRCOM TECHNOLOGIES LTD. could void
the users authority to operate the equipment.
F.C.C. Registration Number: 1M8CAN-22412-OT-E
DC REN: 0.5
AC REN: 0.3B
Notice for all ADC series Telephone Entry System Sold Internationally:
Conformity to the local Tel. Co. standards must be reviewed before installation of ADC Series Telephone Access
Systems.
To Next Page
Loading...
Need help?
General
