MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 26
Example: Ten digit telephone number is required.
Dial Code: 2863
Area Code: 905
Tel. #: 660-4655
Program the system as follows:
Set the telephone digit length to 11 as shown below.
-Program Options-
Enter size as Enter 11 to select eleven digit
07, 08 or 11 = 11 telephone number
Please enter choice:
Set the Code and prefix number.
-Program Options-
Code Prefix #
( 1 ) 905_ Press # to blank out the last (unused) digit.
Please enter choice:
Enter dial Code and Telephone number using the Code for defined Prefix # as described above.
-Program Options-
Code Telephone NOTE: The first digit of the telephone
2863 1660-4655 prefix code, in this case “1".
Please enter choice:
In normal Operating Mode, entering the Dial Code “2863" on the lobby keypad will dial 905 660 4655
through the public telephone network.
ENTER, REVIEW, EDIT or DELETE RESIDENTS’/TENANTS NAMES ON THE LIST
To enter, review, edit or delete Residents'/Tenants’ Names on the list, scroll through until you reach the feature as
shown below.
[1=Bck] [3=Fwd]
Do you want to edit
TENANT Names?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
====TOP-OF-LIST=====
xxxx: <== Second line with “:” displayed can
xxxx be selected by pressing “0".
xxxx Where: xxxx are the Dial Codes.
Note: Press any number to exit.
Press * or # to scroll (review) "up or down" the list . To enter, review, edit and delete the Resident’s/Tenant’s name,
scroll until the desired Access Code and Resident Name is in the second line of the display.
To Next Page
Loading...
