MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 27
Press "0" to enter, edit or delete Dial Code and Resident Name. The next screen should appear....
7 digits telephone # (default) 8 &11 digits telephone #
-Program Options- -Program Options- refer to worksheet
CODE:xxxx@xxx-xxxx CODE:xxxx@xxxx-xxxx <== APPENDIX B
NAME:xxxxxxxxxxxxxxx NAME:xxxxxxxxxxxxxxx <==15 characters max.
Please enter choice: Please enter choice:
1and 3 to scroll "up or down" the character set. Character Set Table is given on Appendix C.
7and 9 to move the cursor "left or right".
# to delete the displayed Dial Code, Telephone number and Resident Name.
After entering Resident/Tenant name, press * . The next screen should appear...
-Program Options-
* = Abort, # = Store
Name:xxxxxxxxxxxxxxx
Please enter choice:
Press * to abort or # to store entry. Repeat the above process until all Residents' /Tenants’ names are entered. When
finished, press any number from 1-9 to return to the PROGRAM MODE menu. To quit, enter *000 while at the
PROGRAM MODE menu to return to NORMAL MODE.
ENTER KEYLESS ENTRY CODES
The system can provide up to 1000 Keyless Entry Codes for Residents and 5 spares for building management.
Entering any valid Keyless Codes on keypad will open the door without the necessity of calling the Resident. For
obvious reasons, keyless entry codes should be kept well guarded and controlled. ADC units will allow the user
to assign a specific code (within the given ranges) that would activate either the Main Door or Auxiliary Door relay.
The main door relay can be activated using the range from 0000 to 4999 and the auxiliary door relay can be activated
using the range from 5000 to 9999. The user is advised to program the unit using these specified ranges if such
operation is required.
[Operation: To open door, press 0 followed by the four digit Keyless Entry Code]
Scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to enter
KEYLESS Codes?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
-Program Options-
KEYLESS Entry
Code #_ _ _ _
Please enter choice:
Enter the four digit Keyless Entry Code. If you make a mistake or wish to reenter the code, press * to enter code
again. The next display should change to...
-Program Options-
#=Store, *=Abort
Code # x x x x
Please enter choice:
Press # to store or * to abort entry. Repeat this process until all codes are entered.
To Next Page
Loading...
Need help?
General
