MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 37
NOTE: Repeat the above process to locate the desired feature.
To exit to Normal Mode, enter *000 while at PROGRAM MODE menu.
RESIDENTS’ DIAL CODE and TELEPHONE NUMBER ENTRY
Residents' Dial Codes can be entered in the format of 1, 2, 3, or 4 digits. These codes are used to call the Residents
using the Entry Panel's keypad. The corresponding “telephone number” for each dial code is set to 7-digits by default.
The system will accept telephone numbers up to 11-digits with 10 user definable 4-digit “Area Code” prefixes.
CAUTION! Before programming the system, the user must determine the maximum telephone number digit
length. Reformatting the telephone digit length will erase those programmed dial codes and
telephone numbers.
SETTING THE TELEPHONE NUMBER DIGIT LENGTH
Scroll through until you reach the feature as shown below.
Max. digits per
listing-Press #
Press # to access the feature. The display should appear...
Enter size as
07, 08 or 11 = _ _
Select: 07 for seven digits telephone numbers (factory default),
08 for eight digits telephone numbers, or
11 for eleven digits telephone numbers
* to abort entry and exit to PROGRAM MODE menu.
NOTE: When 11digits telephone number is selected, the user must set the 4-digit “Area Code” prefix to form
up to an 11 digit telephone number. There are ten user definable prefixes that can be assigned. Factory
default for Prefixes are set to 0905. To assign a new prefix number, follow the instructions described
under “TO CHANGE PREFIX CODES” section below. Prefix numbers are not required for 7 or 8 digits
telephone numbers.
After entering the choice for maximum digits per listing, the screen should change to...
#=Store, *=Abort
07, 08 or 11 = x x
Press # to store or * to abort entry. To quit, enter *000 while at PROGRAM MODE menu.
TO CHANGE THE PREFIX CODES:
To change the Prefix Codes, scroll through until you reach the feature as shown below.
To change PREFIX
Codes - Press #
Press # to access the feature. The display should change to...
Code Prefix # For Code: enter any number from 0 to 9
( _ ) _ _ _ _ For Prefix #: enter up to 4-digit “Area Code”
Where: “Code” (from 0 to 9) is used to call up the corresponding Prefix number.
“Prefix #” (up to 4 digits) is used for “Area Code” number that can be used with standard
To Next Page
Loading...
Need help?
General
