MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 44
NORMAL MODE.
11 DIGIT TELEPHONE NUMBER ENTRY
To program 11-digit telephone number, scroll through until you reach the feature as shown below.
Program 11-digit
No. - Press #
Press # to access the feature. The display should appear...
Code _ _ _ _
_ - _ _ _ - _ _ _ - _ _ _ _
Enter the four digit DIAL CODE followed by the 11-digit telephone number. Please note that a 10-digit telephone
number can be programmed if desired. This is useful for calling a local number with a different area code.
Example: Dial Code 2863
Area Code 905 (local or not a long distance number)
Telephone Number 6604655
Program the system as shown...
Code 2 8 6 3
9 - 0 5 6 - 6 0 4 - 6 5 5 .
Press # to blank the last digit or any digit as desired. When you make a mistake and wish to reenter the code, press
*. After entering all the digits, the display should change to...
#=Store, *= Abort
9 - 0 5 6 - 6 0 4 - 6 5 5 x
Press # to store or * to abort entry. After pressing the store button, the system should exit directly to PROGRAM
MODE. To quit, press *000 while at PROGRAM MODE to return to NORMAL MODE.
QUIT FEATURE
If the visitor picks up the telephone and dials an incorrect resident/tenant code, he has an option of hanging up prior
to connection by pressing the # key twice. The # key must be depressed twice by default. In order to have this
feature by depressing the # key once the following menu must be accessed by scrolling through to reach ...
Pick No.of # key?
Option - press #
Press # to access the feature. The display should appear ...
Once or Twice
O=00 T=11 _ _
Enter 00 to depress # key once or 11 to depress # key twice. The display should appear ...
#=Store, *=Abort
O=00 T=11 _ _
Press # to store or * to abort. The next display should appear ...
Press *
To Exit
Press * to exit to PROGRAM MODE menu. To quit, enter *000 while at the PROGRAM MODE menu to return to
NORMAL MODE.
To Next Page
Loading...
