MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 35
PROGRAMMING INSTRUCTIONS: NON-SCROLLING DIRECTORY
Before programming the system, obtain the required information by using the form provided in APPENDIX "B". After
the system initializations (power up), the display should appear as shown below.
<<< MIRCOM >>>
Please enter the
Resident Code...
This is the Normal Mode of the system. The system will accept all valid codes such as Access Codes, Keyless Entry
Codes, and programming Master Code.
Before entering the Programming Mode for the first time, it is recommended to restore the factory default Master
Code *999 by shorting the reset pins for approximately 3 seconds. Please refer to Fig.12 for location of reset pins.
Note: Shorting the reset pins will only restore the factory default Master Code *999 and will not affect any
programmed information.
ENTERING PROGRAMMING MODE
Enter the MASTER CODE (factory default is *999) to enable PROGRAMMING MODE.
The screen should appear ...
PROGRAM MODE
- Please Wait -
for a few seconds and then the display should change to...
Enter Code or
<*888> for help
This is the PROGRAM MODE menu. At this stage, the system is waiting for valid programming code.
Important note:
Before programming the system for the first time, it is recommended to clear-up all memories and restore all factory defaults by using a special
command *5*5 while at Program Mode menu . Since this special command (*5*5) is a destructive command which can erase all those programmed
information without the provision to undo, the user must take a precaution when using this command.
There are two ways to program the system:
1. Using *888 for Menu Driven type of programming.
2. Using the Direct Access Programming Codes for manual programming. Entering these codes will lead the user
directly to the desired function. The Direct Access Programming Codes are listed on the table below.
Direct Access Programming Codes
Code Function Factory Default Program Choices
*000 Exit Programming Mode *000 n/a NONE
*101 Enter Resident Code and Blank See worksheet 4 digit resident
Telephone # code and up to 8
digit telephone
number
To Next Page
Loading...
Need help?
General
