MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 42
TO CHANGE THE DOOR OPEN CODE FOR AUXILIARY DOOR:
Scroll though until you reach the feature as shown below.
To Change DTMF
Code#2 - Press #
Press # to access the feature. The next display screen should appear...
Enter DTMF digit
to open door ( _ ) Digit “6" is the factory default.
Enter a number from 0 to 9 for code to open the auxiliary door.
Important notice: Do not use the same Code chosen for main door.
The next display screen should appear...
#=Store, *=Abort
to open door ( x )
Press # to store or * to abort entry. To quit, enter *000 while at PROGRAM MODE menu to return to NORMAL
MODE.
SELECT PULSE (Rotary) or TONE (DTMF) DIALING
To select Pulse or Tone (factory default is Tone) dialling, scroll through until you reach the feature as shown below.
Pick Pulse/Tone
Option - press #
Press # to access the feature. The display should appear...
Pulse or Tone
P=00 T=11 _ _
Enter 00 for pulse or 11 for tone. The next display should appear...
#=Store, *=Abort
P=00 T=11 x x
Press # to store or * to abort entry. After pressing the store button, the display should be as shown...
Press *
To exit
Press * to exit to PROGRAM MODE menu. To quit, enter *000 while at PROGRAM MODE menu to return to
NORMAL MODE.
SET DOOR TIMER
To change Door-Open Timer (factory default is 10 seconds), scroll through until you reach the feature as shown
below.
Adjust Door-Open
Timer - Press #
Press # to access the feature. The display should appear...
To Next Page
Loading...
Need help?
General
