MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 39
Dial Code: 2863
Area Code: 905
Tel. #: 660-4655
Program the system as follows:
Set the telephone digit length to 11 as described above.
Enter size as
07, 08 or 11 = 11 Enter 11 to select eleven digit tel. #.
Set the Code and prefix number ( for “Area Code”) as shown below.
Code Prefix #
( 1 ) 9 0 5 . Press # to blanked-out the last (unused) digit.
Enter dial Code and Tel. # using the Code for defined Prefix #:
Code Telephone Note: The first digit is used by prefix Code. In this
2863 1660-4655 case is “1".
At normal operating mode, entering the Dial Code “2863" on keypad, the system will dial 905 660 4655
through the public telephone network.
REVIEW AND DELETE RESIDENT CODES
To review and delete the residents' codes, scroll through until you reach the feature as shown below.
To Edit Resident
Codes - Press #
Press # to access the feature. The next display screen should appear...
Code to Review
_ _ _ _
Enter the code to review. The next typical display should appear...
7 digits telephone # (default) 8 digits telephone # 11 digits telephone #
Code Telephone Code Telephone Code Telephone
xxxx xxx - xxxx xxxx xxxx - xxxx xxxx xxxx - xxxx
Press 1 or 3 to scroll up or down the list.
To delete the displayed Code and Tel. Number, press #.
Press * to exit to PROGRAM MODE menu. To quit, press *000 while at PROGRAM MODE menu to return to
NORMAL MODE.
ENTER KEYLESS ENTRY CODES
The system can provide up to 1000 Keyless Entry Codes for Residents and 5 spares for building management.
Entering any valid Keyless Codes on keypad will open the door without the necessity of calling the Resident. For
obvious reasons, keyless entry codes should be kept well guarded and controlled. ADC units allow the user to
assign a specific code (within the given ranges) that would activate either the Main Door or Auxiliary Door relay. The
main door relay can be activated using the range from 0000 to 4999 and the auxiliary door relay can be activated
using the range from 5000 to 9999. The user is advised to program the unit using these specified ranges if such
operation is required.
[Operation: To open door, press # followed by the four digits Keyless Entry Code]
To Next Page
Loading...
Need help?
General
