MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 33
Press # to blank the last digit or any digit as desired. When you make a mistake and wish to reenter the code, press
*. After entering all the digits, the display should change to...
-Program Options-
#=Store, *= Abort
9 - 0 5 6 - 6 0 4 - 6 5 5 .
Please enter choice:
Press # to store or * to abort entry. After pressing the store button, the system should exit directly to PROGRAM
MODE. To quit, press *000 while at PROGRAM MODE to return to NORMAL MODE.
QUIT FEATURE
If the visitor picks up the telephone and dials an incorrect resident/tenant code, he has an option of hanging up prior
to connection by pressing the # key twice. The # key must be depressed twice by default. In order to have this
feature by depressing the # key once the following menu must be accessed by scrolling through to reach ...
[1=Bck] [3=Fwd]
Do you want to pick
No. Of # signs?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear ...
-Program Options-
# Once or Twice
O=00 T=11 _ _ <== Factory default is 11
Please enter choice:
Enter 00 to depress # key once or 11 to depress # key twice. The display should appear ...
-Program Options-
#=Store, *=Abort
O=00 T=11 x x
Please enter choice:
Press # to store or * to abort entry. After pressing the store button, the system should exit directly to PROGRAM
MODE. To quit, press *000 while at PROGRAM MODE to return to NORMAL MODE.
TO SET ON-LINE TIMER TO MINUTES
To set on-line timer to minutes, scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to pick
minutes or sec?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
-Program Options-
Minutes or seconds
M=11 S=00 _ _ <== Factory default is 00
Please enter choice:
To Next Page
Loading...
Need help?
General
