Mitel 1000 - To Reset Your System

183
Forward on no answer
This is the time that elapses before a call ringing at an extension,
with ’Forward On No Answer’ set, is Forwarded.
Open the door
This is the time that the Doorstrike relay will remain open following
activation.
Doorphone ring duration
This is the time that extensions will ring when the Doorphone is
pressed.
Call Park
This is the time that elapses before a call placed on ‘Call Park’ rings
back the parked call extension
Ringback time duration
This is the time an extension will ring when Ringback has been
invoked.
Ans. Machine delay
This is the time that elapses before an unanswered incoming call is
presented with the Answering Machine greeting.
Programmable message length
This is the maximum length of a message left in a Mailbox or a
Greeting for a Mailbox.
Notification delay
This is the delay between receiving a voice mail message and
attempting a remote notification call.
Notification Interval
This is the delay after making an unsuccessful remote notification
call before attempting another call.
To reset your system
There are two system reset options available – a warm and a cold
reset.
From the Programming extension, press the PROGRAM Key
Press the Scroll Down Key (Ô) until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Press the Scroll Down Key (Ô) until ‘Reset options’ is displayed.
Select ‘Reset!’ or ‘Reset to default!’
WARNING
These are complete system resets, not individual extension
resets. Selecting ‘Reset!’ (warm reset) will reset the system and
cut off all established calls. Selecting ‘Reset to default!’ (cold
reset) will reset the system, cut off all established calls and
remove all programming from the system.