73
This page confirms your PPPoA settings.
6. If you are happy with your settings, click Confirm Changes. The Internet
Access page is displayed.
Configuring a PPPoE ADSL connection
If your ISP’s Internet service uses PPPoE you need to set up a PPP login
account. The first time that you login to the Internet, your ISP will ask you to
enter a username and password so they can check that you are a legitimate
registered Internet service user. Your Mitel 1000 stores these authentication
details so you will not have to enter this username and password every time
you login.
Your ISP may also tell you to set unique path and circuit numbers (called VPI
and VCI) in order to connect your Mitel 1000 to the ISP’s Internet service. In
most cases, your Mitel 1000 will use default settings, so you may not need to
enter these values.
If your ISP wants you to connect to the Internet using PPPoE, follow the
instructions below.
1. From the left-hand Setup menu, click on Router Configuration. The
following page is displayed:
2. Click on ADSL Modem. The following page is displayed:
To Next Page
Loading...
