61
Select ‘Reset the telephone’. The display shows ‘Extension reset’
momentarily before returning to the Idle Menu.
If you are using a standard telephone, dial 739 and wait for the
acknowledgement tone (internal dial tone).
Incoming Call Handling
General
Calls can be presented to the Mitel 1000 on CO lines and VoIP lines.
Calls can be programmed to ring any number of extensions. For configuration
via the web interface, see page 94.
For configuration via the Featurephone interface, see page 164.
When calls are received on a line all free extensions, programmed to ring, are
rung.
Note
Any forwarding set on an extension are ignored for incoming calls
unless the calls are routed to the extension by Caller ID
programming or a caller has dialed through the Answering
Machine or a voice mail box. If a single phone is programmed to
answer calls on a line the forwarding on the phone is acted on. If
the phone has no forwarding set then the line forwarding is acted
on. If more than one phone is programmed the forwarding
options for the line are acted on.
Distinctive Ringing
This feature is primarily intended to support Fax. The Network Operator can
provide a second number on a CO Line that rings with a different signal (teen
line). See page 108 and 116 for distinctive ringing programming on the web
application and page 164 for programming from the programming
Featurephone. The system is then programmed to ring an extension that can
be equipped with a Fax machine when this ringing is detected. All calls with
the normal cadence ring the extensions programmed in the Incoming ringing
programming.
Restricting Outgoing Calls
This feature lets you decide which lines each extension can access for
outgoing calls. By default, all extensions have access to all lines.
For configuration via the web interface, see page 114.
For configuration via the Featurephone interface, see page 165.
Day/Night Service
The ‘Day Service’ / ‘Night Service’ feature allows you to change the
extensions which ring on incoming calls, change the Class of Service at each
extension, and change the voice greeting heard by callers (if you have
voicemail installed). These changes can take place automatically, at pre-
programmed times daily, or can be invoked manually. Furthermore, the
system can be programmed to remain in ‘Night Service’ over the weekend.
For configuration via the web interface, see page 96.
For configuration via the Featurephone interface, see page 166.
System Time/Date
For configuration via the web interface, see page 30.
To Next Page
Loading...
