Using Local Conferencing
Use the following procedure to create a conference call using local conferencing.
1. When you begin a conference, you are the first party in the conference (Party 1). Pickup
the handset or press the key. A line opens up.
2. Call Party 2 by dialing their number (or answer an incoming call of a Party).
3. Wait for Party 2 to answer. When Party 2 answers, you can consult with them before adding
them to the conference.
4. Press the key.
5. Enter the phone number of Party 3.
6. Wait for Party 3 to answer. When Party 3 answers, you can consult with them before adding
them to the conference.
7. Press the key again to add Party 3 to the conference. Party 1 (which is yourself),
Party 2, and Party 3 are all connected to a single conference.
8. To drop a party from the conference, use the
5 or 2 navigation key to select the party and
press the
4Drop key.
IP PHONE UI
Note: Users are able to edit the destination number by pressing the 3 navigation
key, which acts as a Backspace key.
1
1. Martha Gold
2. François Dupont
Leave Drop
1
1. Martha Gold
2. François Dupont
Drop
1
1. Martha Gold
2. François Dupont
Leave Drop
To Next Page
