• Enhanced busy lamp fields*
• Set paging*
*Availability of feature dependant on your phone system or service provider.
REQUIREMENTS
• SIP-based IP PBX system or network installed and running with a SIP account created for
the 6865i phone.
• Access to a Trivial File Transfer Protocol (TFTP), File Transfer Protocol (FTP), Hypertext
Transfer Protocol (HTTP) server, or Hyper Text Transfer Protocol over Secure Sockets
Layer (SSL) (HTTPS).
• Ethernet/Fast Ethernet LAN (10/100 Mbps) (Gigabit Ethernet LAN [1000 Mbps]
recommended).
• Category 5/5e straight-through cabling (Category 6 straight-through cabling required for
optimum Gigabit Ethernet performance).
• Power source:
• For Ethernet networks that supply inline power to the phone (IEEE 802.3af) use an
Ethernet cable to connect from the phone directly to the network for power (no 48V AC
power adapter required if using Power-over-Ethernet [PoE]).
• For Ethernet networks that DO NOT supply power to the phone:
Use only the GlobTek Inc. Limited Power Source [LPS] adapter model no.
GT-41080-1848 (sold separately) to connect from the DC power port on the phone to
a power source
or
Use a PoE power injector or a PoE switch.
INSTALLATION AND SETUP
If your System Administrator has not already setup your 6865i phone, please refer to the Mitel
6865i Installation Guide for basic installation and physical setup. For more advanced
administration and configuration information, System Administrators should refer to the Mitel
SIP IP Phones Administrator Guide.
To Next Page
Loading...
