6. Wait for Party 3 to answer. When Party 3 answers, you can consult with them before adding
them to the Conference 1.
7. Press the key again to add Party 3 to Conference 1. Party 1 (which is yourself),
Party 2, and Party 3 are all connected to Conference 1.
8. Press an available Line key (or answer an incoming call on an available line). If calling out,
call Party 4.
9. Wait for Party 4 to answer. When Party 4 answers, you can consult with them before adding
them to the conference.
10. Press the key to add Party 4 to Conference 1.
11. Press the Line key that has Conference 1.
12. Press the key to join all parties (Parties 1 through 4) on Conference 1.
13. To add more parties, repeat steps 8 through 12.
If any party in the conference hangs up (including the party that began the conference), all other
parties in the conference are still connected.
Setting Up Multiple Conferences (for Sylantro Call Manager only)
1. Start Conference 1 using the procedures in the previous section, “Setting Up a Conference
and Adding Multiple Parties (for Sylantro and BroadSoft Call Managers)”.
2. When you are finished adding all required parties to Conference 1, press an available Line
key to start Conference 2. You are Party 1 on Conference 2. Call Party 2.
3. When Party 2 answers, press the key.
4. Press an available Line key.
5. Call Party 3 for Conference 2.
6. When Party 3 answers, press the key to join Parties 1 (which is yourself), Party 2,
and Party 3 on Conference 2.
You now have two active conferences on two different lines.
If any party in a conference hangs up (including the party that began the conference), all other
parties in the conference are still connected.
Note: The 6865i is limited to 24 conferences (a single conference each on lines 1 through
24).
Note: When you are connected to multiple conference calls, and you put a conference
on hold, the conference may be on hold for a limited period of time before it is
disconnected. Contact your System Administrator for more information.
To Next Page
Loading...
